X-treme eSSB Audio FORUM

Hi everybody

This is my first audio gear but Im really confused to wire the rack processors

here is the processors all from Behringer :


1 ULTRACURVE PRO DEQ2496
2 VIRTUALIZER PRO DSP2024P
3 AUTOCOM PRO-XL MDX1600
4 ULTRAGAIN PRO MIC2200
5 POWERLIGHT PL2000
6 BEHRITONE C50A (monitor speaker)
7 XENYX 502 (mixer)



Thanks.

Just configuration is:
Pr40
mic2200
dsp2024p
deq2496
mdx1600
Mixer
RTX
Howdy! Very nice setup.
I personally have a friend recently set up a rack audio chain in this way with excellent results, very similar to this one.
Too bad for the transceiver in use, the ic7400 is not very suitable for hardly more than 2.9khz bandwidth.
Sorry that so commendable mike rack and is then limited by the rtx, it would be better to combine all of a rtx-bandwidth of at least 4 kHz or higher!
This is at least in my opinion!
best regards from it9bdx!

Thanks Eli for the configuration but i need the wiring connection from channel to channel and for the main time im just using this transceiver , waiting to get Yaesu FT-2000

Amazing, the ft2000 mod 4khz is great rtx, for wiring connection mike in xlr inputs in of mic2200, outputs in the input 1 of dsp2024p, output 1 to input 2 of dsp2024p with jack mono and output 2 foward in L of deq2496, out L to in R of deq2496 and out R to inputs of mdx1600.... Output of mdx1600 to the input of the mixer!
ALL IN GREAT XLR CABLE, Just one connection in to the dsp2024p utilize jack mono!
With the ft2000 mod 4khz no processor, no internal eq and very low mic gain level (aroud 7-8)......
Best results!!!!
Take care de it9bdx!

Alright i have to get some XLR and TRS cables but how about I-BOX can i do that without it just direct to the adapter as shown in the pic above

thanks.

No thanks, really a nice combination rack, setting good then! A single council starts with audio levels before switching to equalization curves!
to feel in the air! 73
Take care!