Page 1 of 1
Posted: Fri Dec 30, 2011 2:25 pm
Just purchased the new Behringer FX2000. I believe it is the replacement for the popular DSP2024 effects processor. I have been using the 2024 for several years with the " Plate " settings found here on this site.
I decided to use both units at the same time. Kept the DSP2024 at the same location, and put the new FX2000 before the commonly used EX3200. The FX2000 has a preset # 62 called ULTRBASS that when used added that little extra low end . This preset sounds amazing natural, and does not sound processed like other psycho acoustic preset do. You can modify this preset to your liking. The FX2000 gives the EX3200 something to work with.
Posted: Sat Jan 11, 2014 6:01 am
Hi Ray! Where are you?!
I've also just got the FX2000 and want to do something like you did with it.
My current setup:
DEQ2496 (with PEQ, DEQ and DYN on)
DSP2024 (sometimes on PLAT, sometimes on STUD)
I've thought to add the FX2000 with preset # 62 ULTRBASS but have to figure out where exactly... Like last piece (after the DSP2024), before the DSP2024, or between DEQ2496 and EX3200... ???
I'd also appreciate some nice settings for the preset #62.
Posted: Sat Jan 11, 2014 6:03 pm
Hi you all!
Hope this will be useful to someone.
Work is in progress, but I've done the following up until now...
My usual setup:
Behringer T-1 microphone
DEQ2496 (with PEQ, DEQ and DYN on) --> I'd like to find out more on this DYN staff, so any suggestion is welcome, although I believe I'll find out on my own soon!
...At the moment the FX2000 is between the compressor MDX2600 and the other effect processor DSP2024 (this one uses PLAT or STUD effects found on this forum). It already does its job but I want to try put it in a couple of other combinations in order to see any difference in audio processing.
I've modified its preset #62 U.BAS original settings... I'll try to post them later if required.
Posted: Mon Jan 13, 2014 8:08 pm
My home band is 11 meters SSB free band.Lots of great ESSB folks to talk too.Back in 2011 ( original post ) I was experimenting with two effects back to back.At that time I wanted plating and ultra bass effects at the same time.
At the time I was trying in change my normal high pitch voice.
I even tried pitch shifting- to lower my voice.
Today 2 years later my rack and my goals have changed.
I no longer except distortion to create a sound that is not my natural voice.
I only use analog gear today .The effects processor is still in line with just a touch of plating.Recently changed it to side chaining .See Mikes post for help on this.